Droplets move to microfluidic chamber music

In principle, setting a droplet in motion inside a microfluidic channel is straightforward: Apply pressure and the liquid flows. In practice, however, precise control of droplet flow simultaneously along multiple channels is technically challenging; conventional pressure pumps are not feasible for microfluidic systems. Inspired by the potential of finely tunable acoustic-pressure generators, a group of engineers at the University of Michigan set out to control droplet motion with music. First, they composed a computer-synthesized sequence of single notes and chords. That signal was then sent to four resonance cavities that were tuned according to their lengths to extract and amplify narrow, non-overlapping frequency bands from the input tones. As shown in the figure and the movie, unidirectional droplet flow was generated from the difference between positive air pressure in the oscillating cavity and relative negative pressure at vent ports near the cavity's outlet. Although the relatively high frequencies of the selected tones produced steady flow, the researchers adjusted the relative amplitudes of the input tones as needed to compensate for variations in average flow velocity. Maybe someday, conducting complex lab-on-chip microfluidic operations will be as simple as stringing together a few musical notes. (S. M. Langelier et al., Proc. Natl. Acad. Sci. USA, in press, doi:10.1073/pnas.0900043106.) — Jermey N. A. Matthews